Pressure switches on the gas train: interpreting faults correctly

Pressure switches monitor on gas flares whether the gas pressure (and for forced-draught burners the air pressure) is within the permissible range. If a pressure switch trips, the control system prevents start-up or shuts the plant down.

Safety note: Work on gas plants, gas trains and electrical components may only be carried out by competent, instructed persons in compliance with the operating manual, the risk assessment and the applicable regulations. This article replaces neither the manufacturer documentation nor an on-site inspection.

Gas pressure switch min. and max.

The Low gas pressure switch (min.) reports insufficient inlet pressure – e.g. with an empty gas holder, clogged filter or closed shut-off valve. The high pressure switch (max.) responds when the pressure exceeds the set value, e.g. with a defective pressure regulator.

Air pressure switch

On flares with a combustion air blower, an air pressure switch checks whether the blower delivers sufficient air. Causes of tripping include dirty intake openings, a defective blower or leaking or kinked sensing lines.

Cause or defective switch?

In most cases the pressure switch reports correctly – the cause lies in the plant. Only if the pressure measurement and switching point do not match is the switch itself suspect. Settings may only be changed as specified in the plant documentation.

Getting a replacement

Note the complete type designation (e.g. GGW, LGW, DG) including pressure range and connection type. Unsure? Send us a photo of the type plate – we will identify the part for you.

Stuck?

A CONTEC service technician will call you back – for all manufacturers, even without a maintenance contract.

Book telephone supportLet us find your spare partView maintenance contracts →

0 replies

Leave a Reply

Want to join the discussion?
Feel free to contribute!

Leave a Reply

Your email address will not be published. Required fields are marked *